产品标题: MVME167-032A使用参数工控控制卡件PLC/DCS系统模块备件设备

型号：MVME167-032A

品牌：MOTOROLA

产品图片展示 

                                                                              产品详情资料：

MVME167-032A

模块说明模块的前盖是可拆卸的。前盖内的跳线插头用于将模块设置为32点或64点I/O模块。出厂默认值为32。要选择32个输入和输出，跳线应位于顶部和中间引脚上，如左侧所示。要选择64个输入和输出，跳线应位于中间和底部引脚上。LED模块有两个LED，显示其运行和通信状态。OK（正常）：表示模块的工作状态。RDY：表示模块的通信状态。通电后，OK（正常）LED应保持点亮。I/O链路主机与模块建立通信后，RDY（RDY）LED将点亮。串行端口模块前部有两个20针连接器，用于连接I/O链路电缆。一个连接器用于连接到链路上的上一个设备的电缆–主设备或另一个从设备。另一个连接器用于连接到链路上的下一个从属设备（如果有）的电缆。有关更多信息，请参阅RX3i I/O链路模块用户手册GFK-2358。信号电平与RS422/485兼容。

                         产品英文详情料:

Module Description The module’s front cover is removable. A jumper plug inside the front cover is used to set up the module as a 32–point or 64–point I/O module. The factory default is 32.To select 32 inputs and outputs, the jumper should be on the top and middle pins as shown at left. To select 64 inputs and outputs, the jumper should be on the middle and bottom pins. LEDs The module has two LEDS that show its operating, and communications status. OK: indicates the module’s operating status. RDY: indicates the module’s communications status. After power–up, the OK LED should remain ON. The RDY LED turns ON after the I/O Link master has established communications with the module. Serial Ports The front of the module has two 20–pin connectors that are used to attach the I/O Link cable. One connector is for the cable to the previous device on the link––either the master or another slave. The other connector is for the cable to the next slave on the link, if there is one. See the RX3i I/O Link Modules User’s Manual, GFK-2358 for more information. Signal levels are RS422/485 compatible.